Voltage Drops; Warning Symbols - Black & Decker CS355 Manual

Voltage drops

Inrush currents cause short-time voltage drops.
Under unfavourable power supply conditions,
other equipment may be affected.
If the system impedance of the power supply is
lower than 0.12 Ω, disturbances are unlikely to
occur.

Warning Symbols

The following symbols are found on the tool:
Warning! To reduce the risk of injury,
the user must read the instruction
manual.
Always wear safety goggles.
Always wear safety hearing
protection.
Features
This tool includes some or all of the following
features.
A. Lock Chain
B. Spark deflector screw
C. Spark deflector
D. Base
E. Fence
F. Vice
G. Flat Wrench
H. Crank
I. Vice Lever
J. Cutting disc
K. Guard
L. Spindle Lock
M. Depth Stop Bolt and Locking Nut
N. Trigger Switch
O. Padlock Hole
P. Fence Bolts
Assembly
Warning! Turn off and unplug the tool before
making any adjustments or removing or installing
attachments or accessories. Be sure the trigger
switch is in the OFF position. Do not make any
adjustment while the wheel is in motion.
Removing and fitting a cutting
disc (fig. 7 - fig 8)
•
Push in the spindle lock (L).
•
Rotate the cutting disc (J) until it locks.
•
Using the flat wrench (G), remove the bolt (S)
by turning counterclockwise and then remove
the washer (T) and the retaining flange (U).
•
Check that the spacer (R) is in place against
the flange.
•
Replace the cutting disc (J). Make sure that
the new disc is placed onto the spacer (R) in
the correct rotational direction.
•
Secure the blade with the retaining flange (U),
the washer (T) and the bolt (S).
•
Push in the spindle lock (L).
•
Rotate the cutting disc (J) until it locks.
•
Using the flat wrench (G), tighten the bolt (S)
by turning clockwise.
•
Move the guard back down and release the
spindle lock (L).
•
Adjust the cutting depth as necessary.
ENGLISH
9