Additional safety instructions
for chopsaws
•
Always wear regular working gloves while
operating this tool.
•
Keep hands away from the cutting disc.
Never cut workpieces that require manual
action closer than 15 cm from the rotating
cutting disc.
•
Do not cut workpieces less than 1.2 mm in
thickness when using the cutting disc
supplied with this tool.
•
Do not operate this tool without guards in
place.
•
Do not perform any operation freehand. Use
the material clamp to clamp the workpiece
securely.
•
Never reach in the back of the cutting disc.
•
Always position the tool on a flat, stable
surface that is well maintained and free of
loose materials, e.g. chips and cut-offs.
•
Before using, inspect the cutting disc for
cracks or flaws. Discard the cutting disc if a
crack or flaw is evident.
•
Make sure the cutting disc is not contacting
the workpiece before the tool is switched on.
•
In operation, avoid bouncing the cutting disc
or giving it rough treatment. If this occurs,
stop the tool and inspect the cutting disc.
•
Do not operate the tool while standing in line
with the cutting disc. Keep other persons
away from the work area.
•
Be aware of cutting chips and the material
being cut. They may be sharp and hot. Allow
cut off parts to cool before handling.
•
The spark deflector becomes hot during use.
Avoid touching or adjusting the spark
deflector immediately after operation.
•
Switch off the tool and wait for the cutting disc
to stop before moving the workpiece or
changing the settings.
•
After switching off, never attempt to stop the
cutting disc by pressing against the side of
the disc.
•
Do not use cutting fluids. These fluids could
ignite or cause electrical shock.
•
Check that the workpiece is properly
supported.
•
Use the cutting discs recommended by the
manufacturer only. Never use circular saw
blades or any other types of toothed blades.
•
The max. allowable speed of the cutting disc
must always be equal to or greater than the
no-load speed of the tool specified on the
nameplate.
•
Do not use cutting discs that do not conform
to the dimensions stated in the technical data.
•
Only use cutting discs that conform to
EN12413.
•
Ensure that the cutting disc is mounted
correctly before use.
•
Let the tool run at no-load in a safe position
for at least 30 seconds. If there is a
considerable vibration or if any other defect
occurs, stop the tool and check it to
determine the cause.
•
Do not use cutting discs for side grinding.
•
Do not cut concrete, brick, tile or ceramic
materials.
ENGLISH
7