Power Supply; Cutting Capacity - Black & Decker BDEBCS14 Instruction Manual

WARNINg:
Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemi cals known to the State of California to cause
cancer, birth defects, or other reproduc tive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNINg:
Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face
and body.
WARNINg:
Always use NIOSH/OSHA approved respiratory protection appropriate for
the dust exposure. Direct particles away from face and body.
For your convenience and safety, the following warnings are on your Heavy-Duty 14 inch
(355mm) Chop Saw:
WARNINg:
FoR SaFe oPeRation ReaD the inStRuction ManuaL.
• Do not uSe tootheD bLaDeS.
• uSe onLY ReinFoRceD WheeLS RateD 4300 RPM oR hiGheR.
• When SeRvicinG uSe onLY iDenticaL RePLaceMent PaRtS.
• aLWaYS: WeaR eYe PRotection, uSe GuaRDS, cLaMP WoRK in viSe, uSe
PRoPeR ReSPiRatoRY PRotection.
• Do not eXPoSe to Rain oR uSe in DaMP LocationS.
SyMBOLS
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ..direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
...............Read instruction manual before use
................Use proper eye protection

POWeR SUPPLy

Be sure your power supply agrees with the nameplate marking. A voltage decrease
of more than 10% will cause a loss of power and overheating.

CUTTINg CAPACITy

The wide vise opening and high pivot point provide cutting capacity for many large pieces.
Use the cutting capacity chart to determine total maximum size of cuts that can be made
with a new wheel.
CAUTION:
CeRTAIN LARge, CIRCULAR OR IRRegULARLy ShAPeD OBJeCTS
MAy ReQUIRe ADDITIONAL hOLDINg MeANS If They CANNOT Be heLD
SeCUReLy IN vISe.
CAUTION:
DO NOT CUT MAgNeSIUM WITh ThIS TOOL.
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
.................earthing terminal
.................safety alert symbol
.../min or rpm ....revolutions or reciprocation
per minute
................ Use proper respiratory protection
.................Use proper hearing protection
4
MAX. mm
2.8
355