Programming A Pause Into The Telephone Number - Menvier Security SD1 + Operator's Manual

Programming a Pause into the Telephone Number

If the SD1+ is connected to an internal PABX telephone exchange, a prefix digit i.e. 9 is normally
required before an outside line can be obtained. Some exchanges also require a pause after this
digit before dialling the telephone number. If required one or more 3 second pauses can be
inserted after the prefix digit.
Before entering the telephone number 0181 234 5678 in the example below, press
out prefix, then press the
1. Ensure that the SD1+ is initialised and the display is showing
"READY" (see page 4).
2. Press
and the unit will display "ENT 1-4 OR 0-C".
[
3. Press
for telephone number 1.
1
1 to 4 will select telephone numbers 1, 2, 3 or 4.
0 to C selects phrases 0, A, B or C (see page 12).
4. The display will alternate between telephone No. 1 and the
current number (Blank if it has not been programmed).
If a telephone number is already programmed, this may
be deleted by pressing the
5. Press
(or your own prefix), and then
9
pause, then press
A pause is displayed as a comma (,).
6. The SD1+ will now show 9, (or your own prefix) on the display.
7. Type in the first phone number 0181 234 5678 and press
8. Repeat for telephone number 2, 3 & 4 as required.
9. When finished, press
The pause option (,) will cause the SD1+ to wait 3 seconds
before dialling the rest of the telephone number.
Programming two (,,) or three (,,,) pause options will cause
the SD1+ to pause 6 or 9 seconds.
10
key three times to select a 3 second Pause.
B
A
key.
B
to move the cursor forward again.
C
to return to the ready prompt.
]
three times to select a
[.
for the dial
9
SD1+
1
READY
SD1+
READY
READY
SD1+
2
ENT 1-4
SD1+
OR 0-C
SD1+
3
4 3
TEL N0 1
SD1+
BLANK
SD1+
5
6 9,
SD1+
7
2345678
SD1+
8
ENT 1-4
3
SD1+
OR 0-C
SD1+
9
READY
SD1+