Programming Telephone Numbers - Menvier Security SD1 + Operator's Manual

Programming: Telephone Numbers
The SD1+ stores up to four telephone numbers, with a maximum of 24 digits each. Permission from
the person(s) being called must be obtained before storing their telephone number. The SD1+
must NOT be used to call the Police via the Emergency Services telephone numbers.
The following example shows how to program telephone number 1 as 0181 234 5678.
1. Ensure that the SD1+ is initialised and the display is showing
"READY" (see page 4).
2. Press
, the unit will display "ENT 1-4 OR 0-C".
[
3. Press
for telephone number 1.
1
1 to 4 will select numbers 1, 2, 3 or 4.
0 to C selects phrases 0, A, B or C (see page 12).
4. The display will alternate between telephone No. 1 and the
current number (Blank if it has not been programmed).
If a telephone number is already programmed, this may
be deleted by pressing the
5. Type in the first phone number 0181 234 5678.
6. If a mistake is made whilst entering the number, press
move the cursor back, re-enter the digit and press
C
Pressing
7. Finish typing in the telephone number and press
8. Repeat for telephone number 2, 3 & 4 as required.
9. When finished, press
In order for the SD1+ to comply with BABT regulations, the
unit must NOT have any telephone numbers programmed
the same.
The SD1+ must NOT be used to call the Police via the
Emergency Services telephone numbers.
8
A
will move the cursor forward again.
to return to the ready prompt.
]
key.
.
C
.
[
1
SD1+
SD1+
2
SD1+
SD1+
3
4 3
SD1+
SD1+
5
SD1+
6
SD1+
to
A
SD1+
7
8 3
SD1+
SD1+
9
SD1+
SD1+
READY
READY
READY
ENT 1-4
OR 0-C
TEL NO 1
BLANK
018153
0181 3
018123
ENT 1-4
OR 0-C
READY