Three Way Calling; Display Messages - Menvier Security SD1 + Operator's Manual

General: Three Way Calling
Three Way Calling is a feature that is available from BT Network Services. For the SD1+ to take
advantage of this facility, the telephone line must have this service enabled (contact BT for details).
When the SD1+ is triggered, the unit checks for "dial tone", if no dial tone is detected i.e. another
telephone is "Off Hook" or there is an incoming call. The unit then sends a "Recall" signal, which is
detected by the exchange as a request for a new line. With a new line available, the SD1+ then
attempts to dial out.
If the SD1+ is connected to an older pulse dial exchange, the numbers being dialled must
be selected to pulse dial (see page 9). This will also disable the three way calling facility as
this is not available on the older exchanges.

Display Messages

PLEASE
SD1+
RECORD
SD1+
SD1+
SD1+
RINGING
SD1+
ENGAGED
SD1+
UNOBTAIN
SD1+
SENT OK
SD1+
NO REPLY
SD1+
PAGED
SD1+
ABORTED
SD1+
16
When the unit is first powered up, a factory restart is required (page 4).
The SD1+ will then have a completely blank memory (no phone
numbers or messages programmed), program these as required. If
the unit is showing this display, and a factory restart has not been
carried out, contact your installation company for further advice.
This is the normal standby display of the SD1+ speech dialler. The unit
will display this message whilst it is doing nothing AND whilst it is dialling
out after it has been triggered.
The SD1+ has detected a ringing signal. This display will only be seen
during a test call and NOT an activation.
The recipient may already be on another call, wait until they have
finished the call and try again. This display will only be seen during a
test call and NOT an activation.
The SD1+ has detected an Unobtainable or Special Information Tone.
Check the number and try again.This display will only be seen during
a test call and NOT an activation.
The SD1+ dialled out, sent the message and was acknowledged
correctly by the recipient. This display will only be seen during a test
call and NOT an activation.
The call was not answered or acknowledged by the recipient. This
display will only be seen during a test call and NOT an activation.
If the SD1+ is programmed to dial a pager number, this message will
be displayed when the pager message is sent. This display will only
be seen during a test call and NOT an activation.
The SD1+ was aborted by a user passcode whilst it was attempting to
dial out following an activation. This display will only be seen
following an activation.