Forcing The Sd1+ To Tone / Pulse Dial - Menvier Security SD1 + Operator's Manual

Forcing The SD1+ to Tone / Pulse Dial

Pulse Dialling: This is the older format and is sometimes referred to as Loop Disconnect/LD. Tone
Dialling: This is the modern format and sometimes referred to as Multiple Frequency/MF. Any or all of
the telephone numbers can be selected to override the automatic format selection and be
forced into dialling the number in one of the above formats if required.
Before entering the telephone number 0181 234 5678 in the example below, press the
select "Pulse Dialling" (P) or press the
1. Ensure that the SD1+ is initialised and the display is showing
"READY" (see page 4).
2. Press
and the unit will display "ENT 1-4 OR 0-C".
[
3. Press
for telephone number 1.
1
1 to 4 will select numbers 1, 2, 3 or 4.
0 to C selects phrases 0, A, B or C (see page 12).
4. The display will alternate between telephone No. 1 and the
current number (Blank if it has not been programmed).
If a telephone number is already programmed, this may
be deleted by pressing the
5. Press the
key once to select "Pulse Dialling" (P).
B
Pressing the
6. Type in the first phone number 0181 234 5678 and press
7. Repeat for telephone number 2, 3 & 4 as required.
8. When finished, press
If the SD1+ is NOT forced to pulse or tone dial, it will
automatically select the correct dialling format.
key to select "Tone Dialling" (T).
C
A
key.
C
key will select "Tone Dialling" (T).
to return to the ready prompt.
]
1
SD1+
SD1+
2
SD1+
SD1+
3
4 3
SD1+
SD1+
5
SD1+
6
SD1+
7
3
SD1+
.
[
SD1+
8
SD1+
3
key to
B
SD1+
READY
READY
READY
ENT 1-4
OR 0-C
TEL N0 1
BLANK
P
2345678
ENT 1-4
OR 0-C
READY
9