Troubleshooting - LawnMaster MEB1246M Operator's Manual

TROUBLESHOOTING

Problem
Handle not in position.
unevenly.
properly.
higher speed
Possible Cause
Carriage bolts not seated properly.
Cam locks not tightened.
Tripped circuit breaker in the house.
height not set properly.
Wet grass clippings sticking to the
underside of the deck.
and blade dragging in heavy grass,
Blade is unbalanced.
Bent motor shaft.
Adjust the height of the handle
and make sure the carriage bolts
are seated properly.
Tighten cam locks.
Reconnect the cord and use the
cord retainer to keep the cord
close to the motor/blade control.
receptacle.
Reset house circuit breaker.
electrician.
replaced by an authorized
service center.
the same cutting height for the
Wait until the grass dries before
Raise cutting height.
Balance the blade by grinding
Stop the motor, disconnect the
damage. Have repaired made by
an authorized service center
before restarting.
22
Solution