Nvr78-Rh Series - Dahua NVR100 series User Manual

Channel indictor
light
IR Receiver

2.1.8 NVR78-RH Series

The front panel is shown as below. See Figure 2-9.
Please refer to the following sheet for front panel button information.
Name
Power button
Number button
Input number
more than 10
Shift
Up/
Down
Left/
Right
ESC
For 4/8/16-channel series product.
The corresponding channel light becomes on when system is
recording.
For 32/64-channel series product:
When the light flashes slowly, it means the corresponding
1-32
channel of 1-16 channel is recording now (Such as channel 1).
When the light flashes fast, it means the corresponding channel
of 17-32 channel is recording now (Such as channel 17)
When the light becomes on, It means the corresponding 2
channels are recoding now (Such as channel 1 and channel 17.).
The channel indictor light here does not show the status of
IR It is to receive the signal from the remote control.
Figure 2-9
Icon Function
Power button, press this button for three seconds to boot up or
shut down NVR.
Input Arabic number
0-9
Switch channel
If you want to input a number more than 10, please click this
-/--
button and then input.
In textbox, click this button to switch between numeral,
English(Small/Capitalized),donation and etc.
Enable or disable tour.
Activate current control, modify setup, and then move up and
down.
、
Increase/decrease numeral.
Assistant function such as PTZ menu.
Shift current activated control, and then move left and right.
⊳
When playback, click these buttons to control playback bar.
ESC Go to previous menu, or cancel current operation.
41