Please refer to the following sheet for detailed information.
Parameter Function
Select speed dome connected channel.
Channel
There are two options: local/remote.
PTZ Type
Please select remote type if you are connecting to the network PTZ.
Select the corresponding dome protocol such as PELCOD.
Protocol
Set corresponding dome address. Default value is 1. Please note
Address
your setup here shall comply with your dome address; otherwise
you can not control the speed dome.
Select the dome baud rate. Default setup is 1115200.
Baud
Rate
Data Bit
The value ranges from 5 to 8. Default setup is 8. Please set according
to the speed dome dial switch setup.
The value ranges from 1 to 2. Default setup is 1. Please set according
Stop bit
Figure 5-103
Figure 5-104
296