Quinny Speedi Instructions For Use & Warranty page 8

>> EN
(25) Push the buttons (1) to open the fastener (2).
• There are D-rings for securing an additional safety
harness. Make sure the safety harness complies
with all safety standards (i.e. BS 6684) before
using it.
(26) The shoulder belts are height adjustable. To change
the height, open the cover on the back and adjust
the clasp both on the front in the cover and in the
board. Tilt the clasp when adjusting.
(27) IMPORTANT: The press studs on the side of the
seat are for attaching a footmuff only.
Bumper bar
(28) Place the bumper bar adapter ('R' on the right side
and 'L' on the left) on the spring-loaded button.
Next, press in the spring-loaded button using the
adapter while at the same time sliding the adapter
downwards until you hear a 'click'. Do this on both
sides.
(29) 'Click' the bumper bar into the openings on the
adapter.
(30) To remove the bumper bar, push in the buttons
and pull the bumper bar forward. The bumper bar
can be swung open by releasing it on one side and
pulling it open.
(31) To remove the adapter, push in the spring-loaded
button while at the same time sliding the adapter
upwards.
Footrest
• The footrest can be adjusted into 2 positions.
(32) Press both buttons under the footrest at the same
time (1) and then adjust the footrest into the
desired position (2).
• IMPORTANT: Never let your child sit or stand on
the footrest.
Back rest adjuster
• The pushchair seat back can be adjusted
continuously from a sitting to a reclining position.
(33) To adjust the back rest, squeeze the adjusting
section on the back (1) and adjust the strap until
the seat is in the desired position (2).
Using the parking brake
• Always use the parking brake when parking Quinny
Speedi, "also when at a standstill".
(34) Step on the pedal on the rear axle to lock the
wheels.
• Always check whether the wheels are locked.
• Release the parking brake by pulling the pedal
upward.
12