Table of Contents
Advertisement
Auto clock set mode
1.
Press the Power button to switch on your radio.
2.
Press the Band button to select FM radio mode.
3.
Press and hold the Menu button to enter the menu setting and then rotate the Tuning control knob until "RBDS
Auto CT" is shown on the display. Press the Tuning control knob to enter the setting.
4.
Rotate the Tuning control knob to select "Auto" and press the Tuning control knob to confirm the setting. Your
radio will synchronize its clock time whenever it tunes to a radio station using RDS / RBDS with CT signals. The
symbol "CT" will appear on the display indicating the radio time is RDS / RBDS clock time.
5.
If you wish to cancel the "RBDS Auto CT" function, press and hold the Menu button and then rotate the Tuning
control knob until "RBDS Auto CT" is shown on the display. Press the Tuning control knob and rotate the Tuning
control knob to select "Manual". Press the Tuning control knob to confirm the setting. Please refer to the later
section "Setting the clock manually" to set the clock time and date.
NOTE
1.
If the clock time was not auto adjusted within 24 hours, the symbol "CT" will disappear on the display.
2.
If clock time from local RDS / RBDS station is not correct, you should consider disabling the "RBDS Auto CT"
function.
3.
Please note that at times the RDS / RBDS signal may broadcast the wrong time, this is the fault of the radio
station and not your radio.
Setting the clock manually
When choosing manual setting as the clock time setting of your radio, the "RBDS Auto CT" function will be disabled.
1.
Press and hold the Menu button to enter the menu setting and then rotate the Tuning control knob until "Clock" is
GB
shown on the display.
2.
Press the Tuning control knob to enter the time setting. The hour digit will flash on the display.
E
3.
Rotate the Tuning control knob to set the desired hour. Then press the Tuning control knob to confirm the setting.
The minute digit will flash on the display.
4.
Rotate the Tuning control knob to set the desired minute and press the Tuning control knob to confirm the setting.
Now the month digit will flash on the display.
5.
Follow the steps above to set the month / day / year. When the time and date setting is completed, the display will
show "Clock Saved".
Setting the time format
1.
Press and hold the Menu button to enter the menu setting and then rotate the Tuning control knob until "12 / 24
hour" is shown on the display.
2.
Press the Tuning control knob and rotate the Tuning control knob to select 12 or 24 hour format. Press the Tuning
control knob to confirm the setting. The selected format is used in standby mode, in playing mode and when
setting the alarms.
Operating the radio
This radio is equipped with three tuning methods – Scan tuning, Manual tuning, Memory presets recall.
Scan tuning FM / AM
1.
Make sure the telescopic antenna is set up in advance.
2.
Press the Power button to switch on your radio.
04
Advertisement
Table of Contents
