Using The Snooze Feature; Deactivating An Alarm Timer; Setting The Sleep Timer; Displaying Signal Information - Sangean ATS-909X2J Operating Instruction

USING THE SNOOZE FEATURE

When an alarm sounds, press any button (except the Power button
to snooze the alarm for 5 minutes. This procedure can be repeated during the alarm
11
period. The Snooze indicator

DEACTIVATING AN ALARM TIMER

If an alarm timer is activated, press the corresponding timer button
Cancel button to deactivate the alarm timer. The corresponding Timer number indicator
31
will now no longer be shown on the display.
M

SETTING THE SLEEP TIMER

The sleep timer allows you to automatically turn off the radio after a preset time has elapsed.
It can be set from 90 minutes to 10 minutes in 10 minute decrements.
To set the sleep timer, press and hold the Power button
sleep time is shown in the Text display
on the display by the Sleep timer indicator

DISPLAYING SIGNAL INFORMATION

The Info button 29 can be used in all modes to display basic information about the signal
that is being received. After tuning to a radio station on the SW, MW, LW or AIR band, or
an FM station that is not broadcasting RDS / RBDS information, repeatedly press the Info
button to display the following information in sequence:
29
1. Preset or page name -
2. Signal RF strength -
3. Signal to Noise ratio -
4. Memory bank A / B / C - Displays the memory bank that is currently being used.
The available layers of information and the information that is displayed are also shown in
the table below:
Layer SW / MW / LW / AIR / FM without RDS or RBDS
1 Preset or page name
2 RSSI -- xxDB
3 SNR -- xxDB
4 MEMOBANK - A / B / C
Note: RSSI: Radio Signal Strength Indication
SNR: Signal to Noise Ratio
NOTE
If your radio is tuned to an FM station that broadcasts RDS / RBDS information, the Info
button 29 can show additional information. Refer to the next section for more information
about RDS and additional information it offers.
is shown on the display while the snooze feature is active.
H
on the display. An active sleep timer is indicated
U
I
.
Display the name of the preset or preset page.
Displays the signal strength in dB.
Displays the signal to noise ratio in dB.
or Backlight button
10
followed by the
5
and release it when the desired
10
JP
EN
61