Setup Of Self-Diagnostic Function - Oki C5500 Maintenance Manual

6. Press the [BACK] key to terminate the test. (The status of Item 1 is restored.)
Indication
FACTORY MODE FACTORY MODE
SHIPPING MODE
FUSE INTACT BELT UNIT ******
Note: ****** is FUSE UNIT ******
either INTACT or K-ID UNIT ******
BLOWN. Y-ID UNIT ******
M-ID UNIT ******
C-ID UNIT ******

5.3.2.11 Setup of self-diagnostic function

This self-diagnosis is practiced to Enable/Disable the error detections of the different types of
sensors.
The error detections can be disabled or enabled temporarily for troubleshooting purposes.
However, this function should be exercised with utmost care, since it is able to set some items that
require specialized knowledge in the field of operation of the engine.
After the function has been used, the set values must always be reset to the defaults.
1. Activate the self-diagnostic (Level 1) mode, and press and hold down the [MENU+] key or
[MENU-] key, until the following message appears.
SENSOR SETTING
2. Pressing the [ENTER] key causes the following message to appear. Press and hold down the
[MENU+] key or [MENU-], until the intended item (See the table below) is displayed.
TONER SENSOR
ENABLE
3. Pressing the [ENTER] key allows to select the set value in the lower line of the display section.
Pressing the [MENU+] key increments the set value.
Pressing the [MENU-] key decrements the set value.
4. Pressing and holding down (3 sec) the [ENTER] key while the value you want to set remains
displayed registers that value on the EEPROM. Then, the status of Item 2 will be restored.
5. Repeat Items 2 to 4, as needed.
43085101TH Rev.1
Set value
For setting the Factory Work mode (Fuse-cut disabled mode).
For canceling the Factory Work mode and enabling the fuse-cut function.
For checking the FUSE status of the transfer belt unit.
For checking the FUSE status of the fuser unit.
For checking the FUSE status of the K-ID unit.
For checking the FUSE status of the Y-ID unit.
For checking the FUSE status of the M-ID unit.
For checking the FUSE status of the C-ID unit.
*
Oki Data CONFIDENTIAL
Function
135 /