Oki C5500 Maintenance Manual page 112

Item
1 PU (PRN) Board Copying of the EEPROM of PU PCB.
Replacement Adjustment purpose: The above data is copied
to another PU PCB in the event that the
current PU PCB needs to be replaced due to
maintenance replacement.
2 PU Serial Number Reprogramming printer serial number
Setting recorded on PU
Adjustment Purpose: Set for a board replaced
for maintenance when it is impossible to copy
EEPROM of the PU board (I/F error etc.)
3 Factory/Shipping Switching between Factory mode and
Mode Shipping mode.
Adjustment purpose: If the EEPROM of the
PU PCB cannot be copied (I/F error, etc.),
setting is made on a maintenance
replacement PCB. Since the maintenance
replacement PCB usually comes set to the
Factory mode, it needs to be set to the
Shipping mode by this function.
4 Replacement of Rewrite of the EEPROM set values of the CU
CU(SP1/TBH) PCB. Adjustment purpose: The EEPROM data
PCB is rewritten to another CU PCB in the event
that the current CU PCB needs to be replaced
due to maintenance replacement.
5 Serial Number Selection of the printer serial number recorded
information setup on the CU, and rewrite of the output mode and
device serial numbers.
6 Set information of Verification of the serial No. information and
PCB items Factory/Shipping mode.
7 USB software Update of USB software
update
8 NIC software Update of NIC software
update
9 NIC Web Page Update of NIC Web Page
update
10 Mac address setup Setup of Mac address
Copying of consumable part counters
11 Consumable part
counter
Drum counter (Y, M, C, K)
maintenance
Fuser counter
function
Belt counter
Toner counter (Y, M, C, K)
Adjustment purpose: When half-used
consumable parts are diverted to another
printer, the value of each consumable part is
copied.
43085101TH Rev.1
Table 5-2 Maintenance Utility Adjustment Items (1/3)
Adjustment
Oki Data CONFIDENTIAL
Operation on
Section No. of the
Operator Panel
Maintenance Utility
(Section No. corresponds to
Operation
the Maintenance manual)
Subsect. 2.4.1.1.1 Invalid operation
Subsect. 2.4.2.1.1,
if copying of
corrected data of
LED head is
involved.
Section 2.4.1.1.2.1 Invalid operation
Section 2.4.1.1.2.2 Subsect. 5.3.2.10
Section 2.4.1.1.6.4
Subsect. 2.4.1.1.3 Invalid operation
Subsect.2.4.1.1.4.3 Invalid operation
Subsect. 2.4.1.1.7 Invalid operation
Section 2.4.2.2.1 Invalid operation
Section 2.4.2.2.2 Invalid operation
Section 2.4.2.2.3 Invalid operation
Section 2.4.2.2.4 Invalid operation
Section 2.4.2.2.4 Invalid operation
112 /