Oki C5500 Maintenance Manual page 175

Message
Service call
220:Error
Service call
230:Error
Service call
231:Error
Service call
250:Error
Service call
251:Error
Power off/on
901:Error
902:Error
Power off/on
903:Error
904:Error
43085101TH Rev.1
Table 7-1-2 Service Call Error (6/7)
Cause
False setting of a Take off the HDD or replaced?
record medium
detected by a print
statistics.
RFID Reader not RFID read device error
Installed
Is the error issued again?
RFID Reader I/F An interface error was detected
Error with the RFID reader device.
01: communication error
between the RFID reader and
the engine PCB.
02: the transceiver circuit error
of the RFID reader.
03: communication error
between the RFID reader and
the Tag chip.
04: the RFID Tag detection
error(more than 4 chips).
Secure File An erasing error of an encrypted
Erasing Error file was detected.
Did the user agree to execute
HDD ERASE?
Secure Disk An error was detected during
Erasing Error Disk ERASE.
Can the error indication be
reproduced?
Short or open in Is belt thermistor cable setting
belt thermistor proper?
detected.
Does error reoccur?
Abnormal tempera- Is belt thermistor cable setting
ture detected by
proper?
belt thermistor
(high-temp or low
Does error reoccur?
temp.)
Error Description
Oki Data CONFIDENTIAL
Solution
Yes
Reset original HDD.
Yes Check the connection of
the RFID R/W board.
Yes
Replace the RFID R/W
board.
Replace the S2V PCB.
01: Same as Error 230
02: Replace RFID R/W
board.
03: Check the antenna
cable connection.
04: Check to see if the
quantity of RFID Tags is
correct.
Notify the user that Disk
ERASE needs to be
executed to erase the
encrypted file, so that
the HDD is restored to
the original state as at
the time of purchase.
ADMIN MENU
HDD ERASE
Turn the power off and
on again.
Yes
Replace the HDD.
No
Connect cable set
operly again.
pr
Yes Turn power ON again.
Yes Replace belt
thermistor.
No Connect cable set
properly again.
Yes Turn power ON again.
Yes Replace belt thermistor
and leave aside for 30
min. Then turn power ON
again.
175 /