Oki C5500 Maintenance Manual page 54

(4) Installation of built-in type hard disk (On C6100 only)
This is a built-in type hard disk to be added to the printer. It is used to conduct confirmation print,
authentication print, to store print jobs, or to make buffer print, and also when the [ COLLATE
FAIL] is indicated in a section-by-section print. Fonts cannot be downloaded to it.
Note! When the printer has a built-in type hard disk installed, make certain to switch off the
printer after executing the shutdown menu. If the power is turned off outright, the hard
disk may be damaged and broken.
Type: HDD-C1B
Memo The hard disk is segmented into the three partitions of "PCL," "Common" and "PSE."
When the printer is shipped out of the factory or the hard disk is initialized, the following
sizes are assigned to the partitions:
Turning OFF the printer power and disconnecting the power cord and printer cable
Note! If an expansion memory is installed with the power switched on, the printer may be
broken.
43085101TH Rev.1
PCL 20%
Common 50%
PSE 30%
O I
Oki Data CONFIDENTIAL
54 /