Table of Contents
Advertisement
User's manual NAVIGON 72xx
1. Insert the memory card into the device (see illustration).
2. Press the card into the device until it locks in place.
Note: The navigation application works only when the memory card
contains the navigation software and card data.
2.5
Navigating with GPS
GPS is based on a total of at least 24 satellites orbiting the Earth and
continuously transmitting signals of their position and time. The GPS
receiver receives this data and calculates its own geographical position
on the basis of the information transmitted by the various satellites.
Data from at least three satellites is required for positioning with an
acceptable degree of accuracy. With data from four or more satellites it
is possible in addition to determine the position's altitude above sea
level. Positioning is accurate to within three metres.
Once the navigation device has determined your position, this position
can be used as a starting point for calculating a route.
The map data on your navigation device includes the geographical
coordinates of all digitally recorded points of interest, streets and
places. This enables the device to calculate a route between a starting
point and a destination.
Calculation of the current position and its representation on the map
takes place once every second. In other words, your current position is
always shown on the map.
3
Switching on the NAVIGON 72xx
1. Press the
switches on. (Approx. 2 seconds)
If password protection has been activated, the E
window opens.
2. Enter the password.
3. Tap on OK.
The N
Note: When you switch on the NAVIGON 72xx for the first time, you
will be asked to make the following settings:
your preferred language for using for the software
►
the unit of length for distances
►
the time format
►
- 14 -
(On/Off) key and keep it pressed until the device
window opens.
AVIGATION
NTER PASSWORD
Switching on the NAVIGON 72xx
Advertisement
Table of Contents
