2010 200 Engine Box Cover/Lifting/Removal - CORRECT CRAFT 100077 Owner's Manual

Section 4

2010 200 Engine Box Cover/Lifting/Removal

The engine box cover is designed as a two-piece clam shell part. Lift
up slightly on the latch located in the front of the box and open fully
until it rest onto the stern seat. Access to the routine service items is
now available. You can leave the top open to dry out the bilge. To
remove the entire engine box, locate the four threaded pins on the
inside corners of the lower clam shell, twist off the wing nuts and
pull the pins out. The engine box can now be lifted out of the boat.
The engine box is hinged on the back side and uses a single latch
on the front side.
LATCH
CORC0274
It uses two long pins to hold down the aft corners of the box and
two short pins to hold down the forward corners.
FORWARD AFT PIN
PIN PIN
CORC0275
4-70