Assemble Legs; Install Optional Fan - Vermont Castings 0003380 Installation And Operating Instructions Manual

Radiance Vent-Free Gas Heater
®
Assemble the Legs
1. Slide stove to the rear of the pallet just far enough to
access rear leg holes. Make sure the stove does not tip
over backwards. (Fig. 6)
Fig. 6 - Slide stove back just far enough to access rear leg holes.
2. Attach the rear legs using 3/8" hex head bolts and flat
washer supplied. Tighten with a 9/16" wrench or socket.
ST720
Remove and discard the large slot-head screws using the
Radiance
flat-blade screwdriver.
slide stove back
3. Carefully tip the stove onto its rear legs. Adjust the pallet
7/30/02 djt
to allow access to one of the front leg holes. Be sure to
leave the pallet under the stove to prevent the stove from
falling fully forward. (Fig. 7)
!
To prevent valve tubing from being crushed or damaged,
make sure to rest valve on wooden pallet.
Fig. 7 - Carefully tip stove onto back legs. Leave pallet under stove
to keep stove from falling fully forward.
4. Have your assistant attach one leg using the hardware
described.
5. Move the pallet to allow access to the other front leg hole.
Attach remaining leg.
9
CAUTION
Washer
Hex Head Bolt
ST721
Radiance
attach
front legs
7/30/02 djt
6. Remove pallet and allow stove to gently rest on all four
legs.
7. Adjust leg levelers to compensate for irregularities in the
hearth.

Install Optional Fan

It is easiest to install the optional fan kit #2767/FK26, before
the stove is moved to its final location or connected to the
gas line.
The fan consists of a blower assembly and a rheostat switch
that are connected by a wire harness. The blower attaches
to a bracket at the bottom of the rear shroud. The rheostat
installs at the bottom of the stove on the left of the valve.
The fan kit includes a 'snapstat', a temperature-sensing
switch which will be mounted to the blower duct just below
the top plate of the stove. The snapstat automatically turns
the fan on or off at approximately 109° F.
The rheostat provides a range of fan speed settings from OFF
(which overrides the snapstat function) to high.
Kit Contents
• Fan assembly with rheostat and snapstat
• wire tie • control knob
!
Sheet metal edges can be sharp. Be sure to wear protective
gloves.
1. Loosen the four phillips head screws which secure the
rear shroud to the stove sides. (Fig. 8)
2. Carefully pull the shroud assembly away from the rear of
the stove.
3. With the rear shroud assembly in the upright position, set
the bottom of the shroud on a padded surface to prevent
scratching the surface. Unfasten the four phillips head
screws which attach the outer shroud to the inner duct
assembly.
Rear Shroud
Assembly
Fig. 8 - Loosen four phillips screws holding rear shroud assembly
and remove. Remove four phillips screws holding rear shroud to
inner duct assembly. Remove rear shroud.
• retaining collar
CAUTION
30005056
ST189
fan remove shroud