Sabo 102-13G Instruction Manual page 152

ENG 44
6.3.4 B
RAKE ADJUSTMENT
If the braking distance becomes longer than
the amount indicated (☛ 5.3.6), the brake
spring will need to be adjusted.
The adjustment will need to be made while
the parking brake is engaged. Access for
making this adjustment is by taking off the
inspection hatch beneath the seat.
Loosen the nut (1) which holds on the bracket
(2) and turn the nut (3) until the length of the
spring is:
A = 47.5 - 49.5 mm (
drive models)
B = 45 - 47 mm (
models)
measured inside the washers. When the adju-
stment has been made, tighten the nut (1).
IMPORTANT
brake unit.
WARNING!
!
adjustment, immediately contact your Dealer. DO NOT ATTEMPT OTHER
WORK ON THE BRAKE THAN DESCRIBED HERE.
6.3.5 A
DJUSTING THE TENSION OF THE DRIVE BELT
If you should notice that forward drive power has dropped, it will be necessary to
adjust the tension of the spring of the stretcher to return to former conditions.
➤
For mechanical
➤
For hydrostatic drive
Do not screw below these values to avoid overloading the
If the brake still does not work properly even after this
MAINTENANCE
2
3
1 3
B
2
A
1