Sabo 102-13G Instruction Manual page 118

ENG 10 UNPACKING AND ASSEMBLY
Line up the hole in the steering wheel hub with the hole in the shaft and insert the
pin supplied (3) using a hammer, ensuring that the end comes completely throu-
gh to the opposite side.
NOTE
To avoid damaging the steering wheel, use a punch or a
screw-driver of the same size as the pin when hammering it in the last part
3.3 FITTING THE SEAT
4
Raise the adjustment lever (3) and fit the
seat (1) in the slide (2), introducing it from
the steering wheel's side, till the seat
engages in one of the 6 positions.
2 1 3
At this point the seat is engaged and can-
not be completely removed unless the
lever (4) is pressed, freeing it from its
retainer
2
3.4 CONNECTING THE BATTERY
4
The battery (1) is situated under the seat
and is held in place by a spring (2).
Connect the red cable (3) to the positive
terminal (+) and the black cable (4) to the
negative terminal (–) using the supplied
3
screws and following the illustrated
sequence. 1