Table of Contents
Advertisement
Hardware Setup
1. Unpack the Retention Set Kit
Gather all of the items included in the retention set kit, as shown in
the following figure.
2. Position the Mainboard
Locate Slot 1 #1 and Slot1 #2 on the mainboard and position the
board in the direction as shown in the following figure:
Supporting Base (x2)
Support Clip (x2)
Screws (x4)
Latches (x4)
Retention Clip (x2)
FAN1: Fan power for CPU in Slot 1
ATX Power
Heat Sink
FAN2: Fan power for CPU in Slot 2
Slot1 #1
Slot1 #2
9
SY-D6IBA
Advertisement
Table of Contents
