Table of Contents
Advertisement
Hardware Setup
Your board comes with four DIMM sockets, providing support for up
to 1GB of main memory using DIMM modules from 8MB to 256MB.
For 66MHz front side bus CPUs use 12ns or faster memory; for
100MHz front side bus CPUs use 8ns (100MHz, PC100 compliant)
memory.
Memory Configuration
Number of
Memory Modules
1
2
3
4
RAM Type
Memory Module
Size (MB)
Notice 1: 256 MB memory modules only available on PC registered DIMM.
Notice 2: Always install memory modules in the order prescribed in this table.
Notice 3: Do not install unbuffered and registered memory modules together.
Important: It is of prime importance that you install DIMM
modules as outlined in the table above in order to preserve
signal integrity on 100MHz front side bus systems.
Step 4. IDE Device Installation (HDD, CD-ROM)
This mainboard offers two primary and secondary IDE device
connectors (IDE1, IDE2.) It can support up to four high-speed HDD
or CD-ROM.
Connect one side of the 40-pin flat cable to the IDE device (HDD or
CD-ROM) and plug the other end to the primary (IDE1) or secondary
(IDE2) directionally keyed IDE connector on the mainboard.
This mainboard can support up to four HDDs.
DIMM 1
DIMM 2
st
1
st
1
st
1
st
1
8/16/32/64/128/256 Mbytes
15
DIMM 3
nd
2
nd
rd
2
3
nd
rd
2
3
SDRAM
SY-D6IBA
DIMM 4
th
4
Advertisement
Table of Contents
