Table of Contents
Advertisement
Hardware Setup
Step 5. Floppy Drive Installation
The system supports 5 possible floppy drive types: 720 KB, 1.2 MB,
1.44 MB, 2.88 MB, and LS-120. In addition, this mainboard supports
a 3-mode (720KB/1.2MB/1.44MB) floppy commonly used in Japan.
Connect one side of the 34-pin flat cable to the floppy drive and plug
the other end to the floppy drive connector on the mainboard.
This mainboard can support up to 2 floppy drives.
Step 6. Front Panel Connections
Plug the computer case's front panel devices to the corresponding
headers on the mainboard.
1. Power LED & KeyLock
Plug the Power LED cable into the 5-pin Keylock header.
Some systems may feature a KeyLock function with a front panel switch
for enabling or disabling the keyboard. Connect the KeyLock switch to
the 5-pin Keylock header on the mainboard, according to the following
pin assignment: pin 1,3 are for Power LED and pin 4,5 are for Keylock.
Power
LED
_
+
Reset
PWRBT
16
SY-D6IBA
Keylock
Speaker
+
_
+
Turbo
LED
_
_
+
HDD LED
Advertisement
Table of Contents
