Grinding Wheels - DeWalt D28116-XE Instruction Manual

Grinding Wheels

Type 27 guard
backing flange
Type 27 hubbed wheel
Type 27 depressed
center wheel
threaded clamp nut
Wire Wheels
Type 27 guard Type 27 guard
75 mm (3")
wire cup brush
MOUNTING AND REMOVING GUARD
D28117, D28137
1. Remove fasteners.
2. Proceed as previously described to slide
guard past the spindle.
Type 27 guard
3. Replace the fasteners.
4. Clamp the guard as previously described.
Fitting and Removing a Grinding or
Cutting Disc (fig. 1, 6, 7)
1. Place the tool on a table, guard up.
2. Fit the inner flange (N) correctly onto the
spindle (O) (fig. 6).
3. Place the disc (P) on the flange (N). When
fitting a disc with a raised center, make sure
that the raised centre (Q) is facing the flange
(N).
4. Screw the outer flange (R) onto the spindle
(O) (fig. 7):
5. Press the spindle lock (B) and rotate the spindle
(O) until it locks in position.
6. Tighten the flange (R) with the two-pin spanner
supplied.
7. Release the spindle lock.
To remove the disc, loosen the flange (R) with the two-
pin spanner.
100 mm (4") WARNING: Do not use a damaged disc.
wire wheel
7
– the ring on the flange (R) must face towards
the disc when fitting a grinding disc (Fig. 7A);
– the ring on the flange (R) must face away
from the disc when fitting a cutting disc
(Fig. 7B).
FIG. 6
R
Q
P
N
O
B
FIG. 7
R
P
N
O
A
R
P
N
O
B