Grinding Wheels - DeWalt D28106-XE Instruction Manual

Grinding Wheels

Type 27 guard
backing flange
Type 27 depressed
center wheel
threaded clamp nut
PADDLE SWITCH (D28402-XE)
WARNING: Before connecting the tool to a power source depress and release the
paddle switch (A) once without depressing the lock-on button (J) to ensure that the
switch is off. Depress and release the paddle switch as described above after any
interruption in power supply to the tool, such as the activation of a ground fault
interrupter, throwing of a circuit breaker, accidental unplugging, or power failure. If the
paddle switch is locked on, the tool will start unexpectedly when it is reconnected.
To turn the tool on, push the lock-off lever (B) toward the back of the tool, then
depress the paddle switch (A). The tool will run while the switch is depressed. Turn
the tool off by releasing the paddle switch.
WARNING: Do not disable the lock-off lever. If the lock-off lever is disabled, the
tool may start unexpectedly when it is laid down.
Type 27 guard
Type 27 hubbed wheel
SLIDER SWITCH
the off position by pressing the rear part of the switch and releasing. Ensure the
switch is in the off position as described above after any interruption in power supply
to the tool, such as the activation of a ground fault interrupter, throwing of a circuit
breaker, accidental unplugging, or power failure. If the switch is locked on when the
power is connected, the tool will start unexpectedly.
To start the tool, slide the ON/OFF switch (L) toward the front of the tool. To stop the
tool, release the ON/OFF switch.
For continuous operation, slide the switch toward the front of the tool and press the
forward part of the switch inward. To stop the tool while operating in continuous
mode, press the rear part of the switch and release.
LOCK-ON BUTTON (D28402-XE)
The lock-on button (J) offers increased comfort in extended use applications. To lock
the tool on, push the lock-off lever (B) toward the back of the tool then depress the
paddle switch (A). With the tool running, depress the lock-on button (J). The tool will
continue to run after the paddle switch is released. To unlock the tool, depress and
release the paddle switch. This will cause the tool to stop.
surface. Lift the tool from the work surface before turning the tool off.
7
Wire Wheels
Type 27 guard
75 mm (3")
wire cup brush
WARNING: Before connecting the tool to a power supply, be sure the switch is in
WARNING: Allow the tool to reach full speed before touching tool to the work
Type 27 guard
100 mm (4")
wire wheel