CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Step #9 Console Mounting:
•
At least one person should hold the Console while the
remaining Console mounting steps are completed
Step #10 Cable Connections :
•
Locate the groud screw; pre-installed into the
back of the Front Mast Mounting Plate
•
Remove the ground screw with Phillips head
screwdriver (not provided)
Truefitness.com / 800.426.6570 / 636.272.7100
•
The fasteners used to attach the Console are
provided in the Console packaging
•
Align the back of the Console with the Front
Mast Console Mounting Plate
•
Attach the Console to the Mounting Plate
by tightening all 4 screw with a Phillips head
screwdriver (not provided)
•
Thread the shaft of the ground screw through the
metal ring attached to the console Ground Wire
•
Re-attach the ground screw to the Front Mast
Mounting Plate
•
Verify that the metal ground ring is compressed
between the head of the ground screw and the
Front Mast Mounting Plate
16