Specifications; Digital Triggers; Static Characteristics - National Instruments NI WLS/ENET-9163 User Manual

Specifications

Note These specifications are for the NI WLS/ENET-9163 carrier only, unless otherwise
noted.
Analog Input

Digital Triggers

1
Performance dependent on type of installed C Series I/O modules and number of channels in the task.
2
Does not include group delay. Refer to C Series I/O module documentation for more information.
3
Stresses beyond those listed under Input voltage protection may cause permanent damage to the device.
© National Instruments Corporation
These specifications are typical at 25 °C unless otherwise noted.
For C Series I/O module specifications, refer to the documentation
included with the modules.
Input FIFO size ...................................... 4095 samples >16 bit
1
Sample rate
NI WLS/ENET-9163 carrier........... 5 MS/s (multi-channel,
With NI WLS/ENET-9215 ............. 100 kS/s, maximum
2
Timing accuracy ................................... 50 ppm of sample rate
2
Timing resolution ................................. 50 ns
Number of channels supported .............. Determined by the C Series

Static Characteristics

Number of terminals .............................. 2 bi-directional, individually
Pull-down resistor .................................. 49.9 kΩ ±0.5%
Input voltage protection
Power–on state ....................................... Input
Required minimum input pulse width.... 100 ns
8191 samples ≤16 bit
aggregate), maximum
I/O module
settable
3
........................ ±20 V on each pin
23 NI WLS/ENET-9163 Carrier User Guide and Specifications