Configuring The Ethernet Connection - National Instruments NI WLS/ENET-9163 User Manual

Caution Remove the C Series I/O module from the NI WLS/ENET-9163 carrier before
you mount the carrier to the panel. After the NI WLS/ENET-9163 carrier is mounted, you
can reinsert the C Series module.

Configuring the Ethernet Connection

© National Instruments Corporation
Mounting the NI WLS/ENET-9000 Series to a Panel
Thread inserts are located in the NI WLS/ENET-9000 Series device for
mounting it to a panel. Refer to Figure 5 for dimensions.
Figure 5. Device Panel Mounting Dimensions
You must have an Ethernet network in order to use the
NI WLS/ENET-9000 Series device. For more information about
configuring your Ethernet connection with the NI WLS/ENET-9000 Series
device, refer to the NI-DAQmx for WLS/ENET Devices Getting Started
Guide that shipped with your device. This document is also accessible from
Start»Programs»National Instruments»NI-DAQ.
(165.10 mm)
11 NI WLS/ENET-9163 Carrier User Guide and Specifications
6.500 in.