Product Briefs And Major Features - Haier XQJ60-31 Service Manual

Product Briefs and Major Features
<1>Product Briefs
(1) Computersequencer
It adopts pouring seal with polyurethane on the surface.The light-emitting diode is sealed with
insulation bushing to avoid humidity. T o avoid splashing,the bottom of the control panel seat
wherethe computer plate is installed adopts enclosed structure,and the surface of the operation
components of the front control board is coated with control panel film.
(2) Structure of the top lid
intergrated top lid structure.
(3) Power transmission system
During washing, the rotation of Motor 1 is transferred to Follower 5 from Drive Wheel 2 through
Belt 3. Meanwhile, Ratchet 7 will be braked by Pawl 8 through the actionforce of the spring, and
the movement will be transferred to Center Gear 9, and then be retarded and transferred to
Tie-rod 10 through a planetary gear mechanismconsisting of Center Gear 9, Planet Gear 10 and
Spin Shaft 4 (inner gear), then Tie-rod 10 is connectedto Pulsator 12 via a spline shaft.Therefore,
Pulsator 12 will movealong with the clockwise and counterclockwise rotation of the Motor 1.
During spinning, the rotation of Motor 1 is transferred to Follower 5 from Drive Wheel 2 through
Belt 3. Meanwhile, Pawl 8 will leave Ratchet 7 by the actionof the puller. Clutch Reed 6is twisted
tightly on the down part of Spin Shaft 4. The Spin tub 13 is connectedto Spin shaft 4 with flange.
The movement of Motor 1 will be retarded by V-belt, and then transferred to Spin shaft 4 and
make the Spin tub 13 to spin.
(4) Damping system
In installing the damping component, please note that the hangers at the motor side are
different from those of the other side. The motor side shall use the yellow spring. The other shall
use white spring.