Table of Contents
Advertisement
8.0 SPARE PARTS
The following comprehensive list of spare parts is available for your B3M or
C3M water heater. Please refer to the Rating Label on the side of your heater
before ordering to ensure the correct spare part is obtained.
DO NOT REPLACE WITH PARTS NOT RECOMMENDED BY HEATRAE
SADIA - THIS WILL INVALIDATE YOUR GUARANTEE AND MAY RENDER
THE INSTALLATION DANGEROUS.
DESCRIPTION
CODE NO.
Element plate assembly - 30/50 litre 3kW ........ 95 606 926
Thermostat .......................................................... 95 612 667
Thermal cut-out ................................................. 95 612 666
Indicator light ..................................................... 95 607 995
Element plate gasket ......................................... 95 611 811
Terminal cover c/w thermostat knob ................. 95 614 184
15mm Push Fit Cap Nut ..................................... 95 607 996
Spout and adaptor ............................................. 95 604 212
9.0 ACCESSORIES
The heater can be used to supply only one outlet when used in an open
outlet installation. More outlets can be supplied in a cystern fed installation.
It is not recommended for supplying a shower. Individual site demands
should be considered when choosing capacity and the number of outlets to
be served.
Tap option packs J, K, M, P, Q, R or S can be used in place of the spout to
provide a single tap outlet. Flow rates will be at a reduced rate.
Note: In an Open Outlet installation it is normal for the spout to drip during
heating. This is due to expansion of water as it is heated within the unit,
it does not indicate a fault. DO NOT attempt to stop this dripping by
over-tightening the inlet tap as damage to the sealing washers or internal
operating mechanism will occur.
16
Advertisement
Table of Contents
