Touchpad Board - HP ENVY x360 Maintenance And Service Manual

TouchPad board

Description
Touchpad board (includes cable)
Before removing the touchpad board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the top cover (see
Remove the touchpad board:
1. Position the top cover upside-down.
2. Remove the three Phillips PM2.0×2.0 broadhead screws (1) that secure the TouchPad board to the
computer.
3. Lift to disengage the cable from the adhesive securing it to the computer (2).
4. Separate the touchpad board from the top cover by pulling it downward away from the top cover (3).
Reverse this procedure to install the touchpad board.
Top cover on page 28).
Spare part number
809387-001
Component replacement procedures 33