Jeep grand cherokee 2015 User Manual page 154

Hide thumbs Also See for grand cherokee 2015:
Table of Contents

Advertisement

ELECTRONICS
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the
HomeLink
button you wish to program while keeping the HomeLink
®
light in view.
3. Push and hold the HomeLink
hold the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink
indicator will flash slowly and then rapidly after HomeLink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
5. At the garage door opener motor (in the garage), locate the "LEARN" or
"TRAINING" button. This can usually be found where the hanging antenna wire
is attached to the garage door opener motor. Firmly push and release the
"LEARN" or "TRAINING" button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has
been pushed.
6. Return to the vehicle and push the programmed HomeLink
(holding the button for two seconds each time). If the device is plugged in and
activates, programming is complete.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to
complete the training.
7. To program the remaining two HomeLink
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the
HomeLink
button you wish to program while keeping the HomeLink
®
light in view.
3. Push and hold the HomeLink
hold the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink
indicator will flash slowly and then rapidly after HomeLink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
152
button you want to program while you push and
®
buttons, repeat each step for each
®
button you want to program while you push and
®
indicator
®
®
has received the
®
button twice
®
indicator
®
®
has received the
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents