Loudspeaker Volume; Outgoing Messages; Answer And Record - Telstra F5050 User Manual

Using the answering machine

Loudspeaker volume

Adjust volume for call screening
The volume ranges from 0 – 7 where 0 = Off, 7 = Maximum.
1. When the base is idle, press
current setting.
Adjust volume for message playback
Volume for playback is adjustable in 7 steps. It is independent from
Call screening but it is linked to the voice prompt volume.
1. During message playback, press
required level.

Outgoing messages

This is the message your caller hears when the answering machine
picks up their call. Your Telstra F5050 comes with two pre-recorded
outgoing messages to choose from. You can also record your own
outgoing messages.

Answer and Record

This allows your caller to leave a message for you.
The pre-recorded message is "Hello, your call cannot be taken at the
moment, so please leave your message after the tone."
or , the display shows the
or , until you reach the
25
You can adjust
the loudspeaker
volume in Standby
mode to set the
call screening
volume and
during message
playback to set
the playback
volume.
The base ringer
can be switched
on and off by
pressing and
holding for
10 seconds.