Dispenser Specifications - Sub-Zero CBBI-36R Design Manual

Dispenser Specifications

Dispenser Area.
For Models ICBBI-42SD and
ICBBI-48SD, the refrigerator door panel must include a
cut-out to accommodate the dispenser glasswell and
bezel. The thickness of the panel in this area can range
from 6 mm to a maximum of 29 mm.
IMPORTANT NOTE: Regardless of the thickness of the
panel for Model ICBBI-42SD or ICBBI-48SD, you must
plan for a flat landing area for the decorative bezel
surrounding the glasswell area. The illustration to the right
provides exact bezel dimensions. Refer to the appropriate
panel specifications page for exact cut-out location. This
landing area can be accomplished in a number of differ-
ent ways. These photos show two options.
One option (flush) is to rout the panel so the bezel will be
flush with rails and stiles. You must rout a space to
accommodate the height and width of the bezel. The
width of the stile immediately adjacent to the bezel must
be 37 mm. Do not cut the entire stile to this dimension.
The other option (proud) shows a boxed out landing area
for the bezel using stiles and rails to create this space. In
this application, the bezel will sit proud of the stiles and
rails. The total thickness of the panels at this level must
not exceed 29 mm.
For overlay and flush inset Models ICBBI-42SD and
ICBBI-48SD, mounting placement of the refrigerator door
handle must assure proper access to the glasswell and
adequate clearance under the handle. The handle place-
ment illustration shows the relation of the refrigerator door
handle to the glasswell bezel on stainless steel models.
Flush option.
16 2
mm
160
mm
radius
327
mm
Dispenser dimensions.
Proud option.
mm
25
mm
3
mm
51
mm
Handle placement.
22
Glasswell
Profile
Handle
Profile