Troubleshooting - Bionaire BCH9222-CN Instruction Leaflet

Trouble
• Remote ☛ Battery low.
Does not ☛ Distance too far.
work.
☛ Display dirty.
• Heater is ☛ When the heater is in Thermostat
Blowing
Cold Air.
☛ Unit is in the Fan Only setting.
☛ Power icon may have been pressed to
• Fan Speed ☛ Max and Heat & $ave
Doesn't
Change.
• Unexpected ☛ You may hear a popping or crackling
Noise.
• Unexpected ☛ There may be an odor or vapor
Smell.
If you have any questions regarding your product or would like to learn more about other Bionaire
contact our Consumer Service Department at 1-800-253-2764 or visit our website at www.bionairecanada.com. For inquiries
regarding recycling and proper disposal of this product, please contact your local waste management facility.
© 2014 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and
distributed by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, 20 B Hereford
Street, Brampton, Ontario L6Y 0M1.
T R O U B L E S H O O T I N G
Troubleshooting for your Heater
Probable Cause
Mode and reaches the set
temperature it will automatically
perform a 15 second cool down
(blowing cold air) to ensure
thermostat accuracy.
turn off the heater.
settings
TM
control the heat output of the heater
and not the fan speed. Fan runs at
the same speed on all settings.
sound as the heater heats up. This is
normal and safe operation. Once the
heater heats up, the crackling sound
will go away.
coming from the heater the first time
you use it or after prolonged or
seasonal storage.
Solution
✔ Change battery (Discription type, 3 volt, CR2025).
✔ Remote works up to 20 feet (6m).
✔ Be sure to point remote at control panel on heater
and there are no obstructions.
✔ Make sure display panel is clean.
✔ Raise the temperature higher or change setting to
Heat & $ave setting or Max.
TM
✔ Press the Max or Heat & $ave
✔ Press the Power icon to turn on the heater.
✔ Run heater in Max for maximum heat output.
✔ If the noise persists call Bionaire
1-800-253-2764.
✔ This is normal and is the result of dust or other debris
accumulating on the heating element. Make sure the
heater is in a well ventilated area and continue
running until the odor or vapor goes away.
icons.
TM
customer service at
®
products, please
®
Printed In China