Cleaning & Maintenance - Bionaire BCH9222-CN Instruction Leaflet

C L E A N I N G / M A I N T E N A N C E
temperature setting before the heater is turned off. However,
if the heater is unplugged, the digital thermostat will no
longer remember the previous temperature setting. You will
need to reset the digital thermostat if the heater is
unplugged.
Oscillation
Press the Oscillation icon (
or on the remote control to activate or deactivate the
oscillation feature.
NOTE: Please do not manually turn the heater on the base.
It is designed to turn only by motorized oscillation.
Timer
Your heater is equipped with 24-Hour Auto Shut-off Timer
feature. This allows you to program your heater to shut off
automatically after running a defined time interval (from 0
to 24 hours).
1. Press the Timer icon ( ) once. The "0 Hr" and arrow
icons will begin to blink for 5 seconds on the LCD display.
After 5 seconds without setting the timer, the heater will
resume the previous mode.
2. Press the Up arrow icon to adjust from 0 to 24 to select
your desired time interval for the heater to shut-off
automatically. The LCD Display will return to the
previously mode.
3. When timer is set, you may check the remaining time
while heater is still in operation. Press the timer icon and
the remaining time (e.g., 7 Hr) will illuminate on the
LCD Display for 3 seconds.
4. To cancel the Timer feature, press the Timer icon ( )
twice within 5 seconds, the Timer icon ( ) will go off.
NOTE: The timer does not work with the FrostProtect
) either on the control panel
setting.
TM
CLEANING/MAINTENANCE
Always unplug the heater before cleaning and allow the
heater to cool down.
1. Clean the unit with a soft cloth moistened with a mild
soap and water solution.
2. NEVER use abrasive or flammable solvents to clean the
unit.
3. After cleaning, be sure to completely dry the unit with a
cloth or towel.
4. Store heater in a cool, dry location.
5. It is recommended that you store the unit in its original
carton.
TIP: Over time, dust may accumulate on the front grills.
This can be removed by wiping the unit with a damp
cloth.