Bionaire BCH9222-CN Instruction Leaflet page 8

Trouble
• Heater Does ☛ Timer Activated.
Not Turn On. ☛ Tip-over switch engaged (only
applicable on models with Tip-over
protection).
☛ Manual user reset is activated.
☛ Not plugged in properly.
☛ Electrical outlet does not hold plug in
securely.
☛ Thermostat set too low.
☛ Obstruction causing the heater not to
operate.
☛ Circuit breaker trips.
• Power icon ☛ Auto Safety Shut-off system is
is Flashing activated when there is potential
or in some overheat.
cases,
Heater Turns
On at Max
Heat setting
but then
Shuts Off in
2 seconds
with Power
icon
Flashing.
• Not Enough ☛ Heater is in Low Heat setting.
Heat. ☛ Thermostat set too low.
• Heater ☛ The thermostat automatically turns
cycles ON the heater on and off to maintain
and OFF selected comfort level.
frequently. ☛ Every 10-15 minute the heater turns
on and runs for a minute.
T R O U B L E S H O O T I N G
Troubleshooting for your Heater
Probable Cause Solution
✔ Press the Power icon to Turn on the Heater.
✔ Set heater upright on a level surface.
✔ Follow reset instructions listed in this manual.
✔ Ensure plug is properly inserted. Make sure electrical
outlet and circuit breaker are working.
✔ Have outlet replaced by a licensed electrician.
✔ Press the Arrow Up icon to achieve the highest
temperature setting.
✔ Unplug the heater and remove all obstructions. Position
your heater 36 inches (0.9 m) away from all objects.
✔ Make sure no other high wattage appliances are
operating on the same circuit and reset breaker if
needed.
✔ Follow Auto Safety Shut-off instructions to reset the
heater.
✔ Change setting to Max.
✔ Press the Arrow Up icon to achieve to the highest
temperature setting.
✔ To make this occur less frequently press the Arrow Up
icon to achieve the highest setting.
✔ This is normal operation to ensure the heater is
maintaining the room temp accurately.