Configure The Https Settings - Panasonic WV-SFV310A Operating Instructions Manual

•
The UPnP function is available when the camera is connected to the IPv4 network. IPv6 is not
supported.
•
To check if auto port forwarding is properly configured, click the [Status] tab on the "Maintenance" page,
and check that the "Enable" is displayed for "Status" of "UPnP". (®page 193)
When "Enable" is not displayed, refer to "Cannot access the camera via the Internet." in the
"21 Troubleshooting" section. (®page 211)
[Camera short cut]
Select whether or not to create the shortcut to the camera on the [Network] folder of the PC. When creating
the shortcut, select "On".
To use the shortcut function to the camera, enable the UPnP function on the PC in advance.
•
Default: Off
Note
•
To display the shortcut to the camera on the [Network] folder of the PC, it is necessary to add the
Windows component. Refer to the following to enable the UPnP function.
For Windows Vista
[Start] ® [Control Panel] ® [Network and Internet] ® [Network and Sharing Center] ® expand the
section of [Network discovery] of [Sharing and Discovery] ® select [Turn on network discovery] ® click
[Apply] ® Complete
For Windows 7
[Start] ® [Control Panel] ® [Network and Internet] ® [Network and Sharing Center] ® select [Turn on
network discovery] of [Network discovery] of [Change advanced sharing settings] ® click [Save
changes] ® Complete
For Windows 8.1 and Windows 8
Right-click [Start] ® select [Control Panel] ® [Network and Internet] ® [Network and Sharing Center]
® select [Turn on network discovery] of [Network discovery] of [Change advanced sharing settings]
® click [Save changes] ® Complete

16.2.5 Configure the HTTPS settings

It is possible to enhance the network security by encrypting the access to cameras using the HTTPS function.
Refer to page 164 for how to configure the HTTPS settings.
16 Configuring the network settings [Network]
Operating Instructions 159