Fitting And Replacing Grinding Tools; Fitting Grinding Tools - HTC 650 HDX User Manual

HTC 650 HDX

4.5. Fitting and replacing grinding tools

Warning!
Disconnect the electrical supply, when changing tools or repairing
the machine.
Warning!
The tool becomes very hot during use. Tip the machine back and
allow it to stand for a short while. Use protective gloves when
removing the tools.
As the machine is equipped with the patented EZchange tool
system, fitting and replacing grinding tools is quick and easy. The
tool system consists of wings on which diamond grinding tools are
fitted without the need for screws.

4.5.1. Fitting grinding tools

1.
Figure 4-9 Fitting grinding tools
2.
1.0
Slide the grinding tool diagonally, from above, down into
the appropriate guide slot on the tool holder, see Figure
4-9 on page 21. Then push the tool fully into the guide
slot.
Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer - see Figure
4-10 on page 22.
Usage
21