Emptying And Cleaning Tanks; Solution Tank - Windsor SCEX264 Operating Instructions Manual

Operations
Machine Operation - Continued
Double Scrub
For floors which are heavily soiled or have thick accu-
mulations of floor finish may not clean sufficiently with
one pass. In these cases it will be necessary to double
scrub.
To double scrub, make the first pass over the surface
being cleaned with the squeegee up, vacuum off, the
solution on, Aqua-Mizer removed and brushes down.
This allows the solution to stay in contact with the soil
while loosening the surface accumulation with the
brushes. Allow time for the first application to stay in
contact with the floor. Length of time between the first
and second pass depends on amount of accumulation
and the type of chemical being used. A second
scrubbing with the squeegee down and again the
solution and brushes on will further loosen soil. The
additional application of solution will further assist the
difficult cleaning job.
FOR SAFETY: When using machine, go slow on
inclines and slippery services.

Emptying and Cleaning Tanks

Park the machine next to a floor drain. Drain hose is on
left rear corner of the machine.
1. Turn the machine power off and set parking brake,
if your machine is equipped with this option.

Solution Tank

1. Loosen small drain hose from the retainer, then
lower hose in direction of the drain.
2. Remove the solution tank cover.
3. Flush the solution tank out with clean water and
run several gallons of clean water through
systems. Do not use water hotter than 140°F
(60°C) to clean tank. Damage may occur.
NOTE: Never allow solution to remain in tank.
Damage to tank, seals and valves could occur.
4. Secure drain hose into the retainer.
18 86400390 Manual Operators - Cutter Euro 24V Deluxe
Recovery Tank
1. Unhook the large drain hose from the retainer.
Unscrew the T-handle on plug enough to loosen
plug, then lower hose in direction of the drain. Do
not stand in front of end of hose. Recovered
solution will come out with force. Slowly remove
plug from drain hose.
2. Remove the recovery tank dome. Flush the
recovery tank out with clean water. Do not use
water hotter than 140°F (60°C) to clean tank.
Damage may occur.
3. Clean off the float shut-off system and inspect for
free movement of float. The float shut-off system is
located in the rear of the recovery tank.
4. Replace the drain plug and secure drain hose in
bracket.
5. If machine is to be stored, leave the recovery tank
dome off.
SOLUTION
TANK COVER
RECOVERY
RECOVERY
TANK COVER
TANK DRAIN
SOLUTION
TANK DRAIN