Fire Hazard; Noise Hazard; Protect Your Equipment - Simadre CT5200D Owner's Manual

 Wear a welding helmet with UV-blocking glass
 Wear UV-opaque work clothing
 Wear welding gloves while using the CT5200D/DX
 Make sure other people near the work area are
properly protected against UV radiation
 Sparks from welding or plasma cutting can start fires,
so remove all flammable materials from the work
area.
 Keep a fire extinguisher nearby and know how to use
it.
 Hearing protection is recommended while using the CT5200D/DX
 If the CT5200D/DX is kept in a dusty environment, it should be kept covered.
Especially in a metal working shop, the dust can be electrically conductive
and thus can create an electrical hazard.
 Keep the CT5200D/DX at least 12" from the wall
 Maintain good ventilation in the work area
 If you operate the CT5200D/DX outdoors, make sure it is sheltered from sun,
rain, snow, and dust.
 Do not store corrosive liquids or gases close to the CT5200D/DX.
 If the machine is overloaded, it will automatically shut off. If it shuts off,
simply turn it off and allow it to cool for a few minutes.
 Power surges can damage the equipment, so it should not be used when there
is a high risk of power surges, such as during severe storms. Damage caused
by power surges is not covered by the warranty.

Protect your equipment

Fire Hazard

Noise Hazard