Safety Warnings And Recommendations - Simadre CT5200D Owner's Manual

SAFETY WARNINGS AND RECOMMENDATIONS

Welding and plasma cutting are dangerous activities, both to the operator and to people in
or near the working area, if the equipment is not operated correctly. All safety rules
should be strictly observed while operating this equipment.
Please read this instruction manual carefully and make sure you understand it before
installing and operating the CT5200D/DX.
 Only a trained operator should use the
CT5200D/DX
 Make sure the electrical supply to the
CT5200D/DX is properly protected by fuse or
circuit breaker (30 Amp), and meets all relevant
electrical codes.
 Connect the grounding wire according to
electrical codes
 Disconnect the CT5200D/DX from its electrical
supply before doing any maintenance on the equipment and before
disconnecting any cables from the equipment.
 Always disconnect the arc/MMA electrode
cable from the CT5200D/DX front panel
before either plasma cutting or TIG welding.
 Do not make skin contact with live
components of the welding circuit.
 Wear dry welding gloves while operating the
equipment
 Make sure the work area is well ventilated
 We recommend using a welding mask that supplies
fresh air
Electric shock can be fatal!
Smoke and gas generated
while welding or plasma cutting
is harmful to your health!
UV Light is harmful to
eyes and skin!