9.5. Fuel Tap (Cock)
9.5.1. Stop the engine.
9.5.2. Empty fuel tank and make sure fuel tap is higher than the fuel
inside the tank
9.5.3. Turn the fuel tap (cock) lever to "OFF".
9.5.4. Clean with solvent.
9.5.5. Wipe off.
9.5.6. Check filter, clean as required.
9.5.7. Check the gasket. Replace it if damaged.
Fuel tap shown in ON position.
9.6. Fuel Tank Filter
On completion make sure fuel filler cap is secured tightly.
9.6.1. Remove filler cap.
9.6.2. Remove fuel filter and clean with solvent.
9.6.3. Wipe off and dry with a clean lint free rag.
9.6.4. Replace filter into fuel tank.
9.7. Silencer Cover
The engine and silencer will become very hot after the engine has been run. Avoid
touching the engine and silencer while they are still hot with any part of your body or clothing
during inspection or repair.
9.7.1. Make sure silencer and exhaust are cold before continuing this work.
9.7.2. Remove the silencer protector and silencer screen.
9.7.3. Clean the carbon deposits out of the silencer screen using a wire brush.
9.7.4. Check the silencer screen. Replace it if damaged.
9.7.5. Install the silencer screen and silencer protector.
Page 17
Rev 3