BMW C 650 GT Rider's Manual page 96

8
94
Slacken adjusting screws 2 on
left and right.
Push adapters 3 on left and
right apart until the front forks
z
fit between them.
Use locating pins 4 on left and
right to set the front-wheel
stand to the desired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
Align adapters 3 on left and
right so that the front forks are
securely seated.
Tighten adjusting screws 2 on
left and right.
http://www.motorcycle.in.th
If the Scooter is raised too
far the centre stand will
lift clear of the ground and the
Scooter could topple to one side.
When raising the vehicle, make
sure that the centre stand re-
mains on the ground. If neces-
sary, adjust the height of the
front-wheel stand.
Apply uniform pressure to push
the front-wheel stand down
and raise the Scooter.
Make sure the Scooter is
standing firmly.