Yowza Boca Assembly Instructions And Owner's Manual page 55

http://www.yowzafitness.com/ 55
COMPUTER OPERATION
The third 3 minutes warm up
If the actual PULSE rate didn't reach the Preset target workout pulse rate 65%, program will continue to perform the third "WARM
UP"
The "DISTANCE and CALORIES" will count up from the second WARM UP. The 3 minutes warm up program will count down from
the pre-set time.
SPEED and INCLINE level will stay at the end of second WARM UP section.
In the third "WARM UP" section, SPEED increase and INCLINE motion automatically will be canceled.
In the third "WARM UP" section,
If the pulse is not detected by hand pulse sensor, the speed will decrease 2.4KM/1.5ML. When
speed decrease to a minimum, INCLINE will decrease 1%. Both SPEED and INCLINE are decreasing to a minimum, stop
decreasing motion.
If the third WARM UP section still cannot bring up the actual pulse rate to the preset target workout Max.pulse rate, treadmill will
continue to perform running until 3 minutes warm up section finished, "SPEED" display will show a blinking "FAIL".10 seconds later,
the program will return to power on status. At this point, speed and incline will back to original position.
During the third "WARM UP" section, if the actual PULSE rate has reached or exceed the Preset target workout pulse rate 65%
twice , 3 minutes warm up is completed and then enter into the HEART CONTROL PROGRAM.
Heart rate main program
After the actual pulse rate reaches the preset target workout Max. pulse rate and completes the warm up section, the computer will
enter into the heart rate main program and the time will count down from the pre-set time. During the main program, the time will
count down to the end. The DISTANCE, CALORIES will continue to count up from the "Warm up" section. SPEED and INCLINE
level will continue running as last warm up section.
Pulse rate will be detected automatically by hand pulse sensor, which have "INCLINE LEVEL" change. When INCLINE LEVEL
increased to a highest level or reduced to a lowest level, which can't control "real pulse rate " change, then program will s witch to
control "SPEED" change. The computer will detect the users pulse rate every 30 seconds.
If the actual pulse rate is lower than preset target workout Max. pulse rate, the INCLINE LEVEL will be increased 1 level. INCLINE
LEVEL will stop increasing until the actual pulse rate reach the preset target workout Max. pulse rate.
If the actual pulse rate is higher than preset target workout Max. pulse rate, the INCLINE LEVEL will be reduced 1 level every 30
seconds until the actual pulse rate meets the preset target workout Max. pulse rate, INCLINE LEVEL will stop reducing.
If the real pulse rate is not defected by hand pulse sensor, the SPEED will decrease 2.2KM/1.4ML. When speed decrease to a
minimum, INCLIE LEVEL will decrease 1%. Both SPEED and INCLINE are decreasing to a minimum, stop decreasing motion.
When the actual PULSE rate is higher than the Preset target workout Max.pulse rate for 3 minutes, heart rate main program
automatically stop working, and enter into the "COOL DOWN" function.
If the actual pulse rate is not defect by hand pulse sensor, "PULSE" display will show a blinking"P" until pulse is defect.
At the end of preset time or actual pulse rate is higher than the preset target workout Max.pulse, the computer will stop the Target
pulse program ,and program will enter into "COOL DOWN" function with 1 minute