Yowza Boca Assembly Instructions And Owner's Manual page 47

http://www.yowzafitness.com/ 47
COMPUTER OPERATION
STANDBY MODE
When the computer display is lit first, "WEIGHT" icon will be blinking
QUICK START MODE
When computer is on standby, press the START button to enter quick start workout mode. The treadmill will count down from 3 to
zero and then the belt start at 1.0KM/H or 0.6 MPH speed. The workout Time, Distance and approximate Calories figure will count up
from 0(zero). The running speed will also display on LCD screen. User can press SPEED UP/DOWN button to adjust running speed,
and press INCLINE-UP and INCLINE-DOWN buttons to adjust the INCLINE level. User press the START button, the program will
automatically calibrate action "elevation height of the treadmill"
Press the STOP button to pause the program, and START to restart, or press STOP again to return to POWER ON MODE.
COOL DOWN
After completion of each program the TIME LCD window will show "COOL" and blink then start a 50 seconds cool down procedure.
Time counts down from 01:00 to 00:00 and speed stays at 2MPH / 3.2 KM/H and the incline level stays at level 0. Press the STOP
button to return to POWER ON status. To escape the cool down procedure press the STOP button once anytime during the process
to enter the PAUSE status and press the STOP button again to enter the POWER ON status.
SLEEP MODE
When the power is on the computer will automatically enter SLEEP MODE if there is no movement for 3 minutes without receiving
any input. Press any button to return to POWER ON MODE when the computer is in the SLEEP MODE.
UNIT CONVERSION MODE – (KM / ML.)
Power on the treadmill, press and hold the START button then push the safety key up to light up the computer. The console will enter
into the UNIT CONVERSION MODE. The console will sound a BEEP and show the current default setting KM (kilometers) or
MPH(miles). Use the START button to switch between KM and MPH. Press the STOP button to confirm the selection and return to
POWER ON MODE. The console will sound an extended BEEP as it saves the new setting. To exit UNIT CONVERSION MODE
without saving use the STOP button.
FAN OPERATION
POWER ON computer, press the FAN button to turn it on.There are total of 3 air regulation, press the FAN button first to start 1 level
,press the FAN button twice to start 2 level, press the FAN button three to start 3 level, press the FAN button four to turn it off. LED
light will be lighted under the FAN icon when user adjust the air regulation.