Revo R4-8-16DVR2 User Manual page 73

NOTE: If the image cannot be displayed properly because of your PC's specifications, lower the drawing mode level.
NOTE: While in the Fast Drawing mode, the drawing speed might decrease when the Netcon screen is not located
on the primary monitor.
NOTE: Overlay drawing mode may not be supported, depending on the type of video card installed in your PC.
Video cards with an ATI chipset are recommended.
NOTE: When using dual monitors, selecting Overlay drawing will display the image only on the primary monitor.
NOTE: When using a low-end computer, image drawing speed might decrease while using a deinterlace filter
depending on the type of deinterlace filter.
NOTE: When using a low-end computer, image drawing speed might decrease when the Anti-Aliasing Screen
option is selected.
OSD Setup...: Select options to display on the screen.
–
Load Default Map at Startup: Select whether or not the user-defined map file is loaded automatically when Netcon
–
starts, and designate the path of the map file (.rmp) to load.
 Recording Setup: Set up the Use (On or Off) of the panic recording function and overwriting option of the recording
folder (On or Off). When using the panic recording function and overwriting option, Netcon continues recording when
the hard disk drive is full by overwriting the oldest video. Designate a recording folder path and set the recording
folder size from 640MB to 2,048MB. Capacity shows the remaining space of the recording folder.
NOTE: The recording folder size cannot be changed once it has been set. Designate another recording folder
path if you want to expand the recording space.
Recording Mode Setup...: Set up the panic recording mode.
–
NOTE: Panic recoding will NOT be made for the cameras currently not displayed on the Watch screen even though
they are set up to be recorded.
NOTE: When selecting the User Assignment Setup mode, the user can assign camera channels to record manually
on the Watch screen. Select a camera on the Watch screen and click the right mouse button then select Set Record
Camera in the text menu screen. The gray
 Normal Drawing: Depends on your PC's CPU performance and displays images
in low speed (DIB Draw Mode).
 Fast Drawing (Default): Displays image in normal speed (Direct Draw Mode).
 Fast Drawing (YUV420/RGB32): Depends on your PC's video card performance
and displays images in high speed (Direct Draw Mode).
 Overlay (YUV420/RGB32/RGB565): Displays image in high speed (Direct Draw
Overlay Mode).
 Deinterlacing: Set up the deinterlace filter. Using a deinterlace filter for interlaced
video enhances image display quality by eliminating horizontal scan lines and noise
in areas with motion.
 Aspect Ratio: Set up the image aspect ratio displayed on the screen. Selecting Fit
to Screen displays images by fitting them to the screen size, and selecting Original
Ratio displays images by fitting them within the screen size while maintaining
their original ratio.
 Anti-Aliasing Screen: Set up the Anti-Aliasing Screen option. When using the Anti-
Aliasing Screen option, the image display quality on the screen will be enhanced
by eliminating stair-stepping (aliasing) effects in the enlarged image.
 Visible Watch Camera: Records camera channels currently displayed on the Watch
screen.
 User Assignment Setup: Records camera channels assigned by the user on the Watch
screen.
 Camera Range Setup: Records camera channels within preset channel range. Select
the boxes beside Camera and adjust camera range up to 16 channels.
icon displays on the selected camera screen.
Netcon (Remote Administration System)
17