Infrared Remote Control - Revo R4-8-16DVR2 User Manual

INFRARED REMOTE CONTROL

ID Button
If a DVR System ID is set to 0, the infrared remote control will control that DVR without any additional entries. (Refer
to the Main Setup section in this chapter for further information on setting the System ID.) If the DVR system ID is 1 to 16,
you must to press the ID button on the remote control followed by the number button (1 to 16) in order to control that
DVR. If two or more DVRs have the same ID, those DVRs will react to the infrared remote control at the same time.
DISPLAY Button
Pressing the DISPLAY button toggles between different display formats. The available formats are: full, 4x4, 3x3, 2x2
and PIP.
When the DVR does not detect a VGA monitor automatically, pressing and holding the button for 5 seconds or longer
will toggle the video output between the composite video output and VGA out. During clip copy, you cannot switch
the video output mode.
SEQUENCE Button
When in the Live Monitoring mode, pressing the SEQUENCE button displays live channels sequentially.
FREEZE Button
Pressing the FREEZE button freezes the current live screen.
ID
DISPLAY
SEQUENCE
FREEZE
ALARM
CAMERA
PTZ Control (FOCUS, PRESET, ZOOM)
MENU
PTZ Mode
Arrows
Enter
ZOOM Mode
PLAYBACK
(Stop, Pause, Play, RW, FF, Next, Previous)
Digital Video Recorder
7